apple flower 3D 打印模型

print ready apple flower. but you are free to think that it is a sakura blossom.



measure units are millimeters, it is about 2 cm in diameter.


mesh is manifold, no holes, no inverted faces, no bad contiguous edges.

here is two version of the flower:

1) a_flower_solid. (.blend, .fbx, .obj, .stl) it is the solid version with flat back side. **048 triangular faces.
2) a_flower_hollow. (.blend, .fbx, .obj, .stl) this version is concaved at back side, so the wall thickness is about 1 mm. 92660 triangular faces.


available formats: .blend, .stl, .obj, .fbx