BOSCH ARM割草机电机叶轮和皮带轮 3D 打印模型

描述

**Impeller and pulley of the BOSCH ARM lawnmower motor**



**Specification:**

- Impeller and pulley of the BOSCH ARM lawnmower motor

- Impeller printing from PETG
- Pulley printing from PA6

- To install a new pulley, the motor anchor must be pre-waste on a lathe by grinding
the old pulley to a depth of 15mm, followed by threading M8 on the anchor shaft.

- When installing the pulley, use the M8 nut with a nylon insert.


**Included formats:**

*.obj, *.stl, *.3mf


https://youtu.be/uMMGjr2oAzc


All dimensions are accurate. This model printed and tested successfully.