Форма для лиття під тиском старовинного тягового трактора. Масштаб задньої шини 3D Принт Модель

Форма для лиття під тиском старовинного тягового трактора. Масштаб задньої шини 3D Принт Модель iges, sat, step, stl, iges, sat, step, stl, iges, sat, step, stl, від tommy250max

The mold is intended for the tire manufacture from silicone or similar flexible material in scale 1:10, 1:14, 1:25. It consists of 2 parts: top and bottom part. Each part can be 3D printed without supports.

Mold dimensions 1:10:

- diameter – 200 mm

- height – 85 mm

Tire dimensions 1:10:

-        outer diameter – 160 mm

-        overall width – 70 mm

-        inner diameter – 85 mm

Mold dimensions 1:14:

- diameter – 155 mm

- height – 60 mm

Tire dimensions 1:14:

-        outer diameter – 115 mm

-        overall width – 50 mm

-        inner diameter – 60,75 mm

Mold dimensions 1:25:

- diameter – 104 mm

- height – 38 mm

Tire dimensions 1:25:

-        outer diameter – 64 mm

-        overall width – 28 mm

-        inner diameter – 34 mm

If you want a different wheel size, simply scale the mold.

The bottom mold part has 5 special bosses and Top mold part has 5 special holes to guide mold parts in the closed state. Also, there are 4 slots for better opening with a screwdriver or similar instrument.

In the Top mold part are 4 small holes for material injection.

Both mold parts have 4 holes with diameter 6 mm for bolting it in closed state.

Note! Only the mold! This is not a tire!