woman body for vase mode 3D प्रिंट मॉडल

highly optimised version to be printed easily and faster in vase mode!

recommended settings with 0.4 mm nozzle:

optimisations:

head cut at a greater angle for ***ter overhang
slightly lower shoulders for ***ter overhang
reduced pit above the clavicle
adding venetian dimples
most proportioned body
increased definition ***ween the legs and the buttocks
fixed the hole ***ween legs

3d printing settings
cura: special modes -> spiralize outer contour
s3d: layer -> single outline (vase mode)
slic3r: print setting -> spiral vase

no support!

50% size ( 30 minute):
layer height: = 0.10 - 0.11 mm
line width/extrusion width: 0.55*
speed: 30 mm/sec or slower! (20 mm/sec wall)
minimum layer time: 3s
temperature: +5c
fan: 75%**

100% size (90 minute):
layer height: 0.12 - 0.13 mm
line width/extrusion width: 0.65*
speed: 40 mm/sec or slower! (25 mm/sec wall)
minimum layer time: 6s
temperature: +10 c°
fan: 75%**

200% size (230 minute):
layer height: 0.16 - 0.17 mm
line width/extrusion width: 0.8*
speed: 50 mm/sec or slower! (30 mm/sec wall)
minimum layer time: 10s
temperature: +15 c°
fan: 75%**

*yes, it is possible to change the width of the line, up to 0.8 mm even with a nozzle from 0.4 mm
**only for pla and for ***ter interlayer adhesion, but if the overhang are wrong, increased to 100 as well. (petg 100%, abs 0%)