PCB의 FCT 기능 테스트를 위한 자동 라인 3D 모델

설명

the unmanned automatic test line can be used in the electronic factory, so the pcb board and various function test equipment are about 10 meters long, including more than 50 ordinary motors, more than 30 cylinders, more than 10 stepper motors, dozens of screw rod slide rails. the structure of the line body is relatively complex, the structure of the conveying type used is more, and other testing instruments are also included as you can see, the latest automatic line body equipment for electronic pcb board function test is as follows: the pcb board comes out of the storage machine and goes from the connection desk to the conveyor belt in the ict equipment. the cylinder drives the whole belt line and pcb down to the bottom test needle board, so that all the solder joints of the pcb board contact with the probe to start the test. at the same time, the cylinder above the pcb board also drops to press the board in place for testing. after a few seconds, the cylinder drives the conveyor belt to the original position, indicating that the test is completed the cb board begins to flow into the next work station, fct tests the high-voltage and endurance parameters, and sends the circuit board to the fct tester through the elevator. the fct is divided into two layers, i.e. upper and lower layers. the test efficiency is quite high. the total height of the automatic elevator at both ends of the test machine is more than 2m. it is mainly used to transport and lift pcb boards at both ends of the tester, after the test is ok, the product flows out of the line and enters the harvester. the overall equipment structure is stable and the cost is low. after the complete set of drawings are downloaded, you can directly watch and edit the contents. welcome to download and learn from your favorite friends. 프린트 준비: 아니오