Narsil-Anduril 북마크 3D 프린트 모델

설명

"Narsil is my name, a mighty sword, Telchar made me in Nogrod."

At that moment Isildur took the broken sword of his father, Narsil, and cut off Sauron's finger with the One Ring.

Elendil's sword, the one that had been broken during the war against Sauron, was forged again, at the end of the Third Age, for Aragorn, receiving then a new name: Andúril, the Flame of the West.

"Sun. I am Andúril, who was Narsil, the sword of Elendil. Let the minions of Mordor flee from me. Moon. "

This is a bookmark version of Narsil's broken blade, which was forged back into Anduril, where the Narsil fragment acts as a clip to mark the pages. Included separately, Narsil (fragment) and Anduril (complete).
----------------------------------------------------------------------------------------If the sheet is printed upwards, it is recommended to establish a good support to achieve a good finish afterwards.

The model has total dimensions of 150x41x3 mm, if considered, it can be widened a little more than 3mm to get more robustness, but it is not recommended to print with a lower thickness.

Once printed, carefully remove the backing and bend slightly along the crack to slightly separate both parts and create the clip. 프린트 준비: 아니오