steampunk lamp 3D 프린트 모델

printable steampunk lamp model with the touch sensor (see link below) you have a 3 position switch dimmer.
fits in the 3/4" tee connector

to conect the valve wheel i used a 6 mm bold with a m6 cap nut the nut serves as the touch sensor
https://youtu.be/gja_dbcck-0

https://www.banggood.com/custlink/gkvv0v1un6

3d printing settings
3d printing settings
0.2 mm layer
3 perimeter
3 top /bottom layer

you can also use a normal 220-240 v switch.

if you are not familiar with electricity let the wiring be done by a friend who knows

3d printing settings
0.2 mm layer
3 perimeter
3 top /bottom layer 프린트 준비: 아니오