VACUUM CHAMBER 3D 프린트 모델

A chamber with a volume of 800-900 ml, it is ***ter to print a chamber made of transparent material, for degassing silicone and other two component solutions, you do not need a pump , a syringe is enough , I use it myself in jewelry, for degassing silicone under molds .personal development .To use it , it is enough to print and assemble it, find a flat rubber band that is not needed, put a lid on it and pump out the air , then I myself will cut a vacuum gauge into the case and to relieve pressure , now I have to move the camera sideways on a glass table until it jumps off and the pressure equalizes) Printing 4 hours , 0.15 mm layer , illumination time 6 seconds , standard resin . (photon mono x)
all the details in the file are printed without support from the table , the necessary transitions were laid in the model . just upload the finished file , slice and done .resin consumption 280 ml