crankshaft with pistons Безкоштовні 3D Моделі

$
0.00 USD
- Запит на підтримку продукту від автора
- Доступні формати:
- ID Товару:223658
- Дата: 2019-01-05
- Анімована:No
- Текстури:No
- Скелет:No
- Матеріали:No
- Лоу-полі:No
- Колекція:No
- UVW зображення:No
- Плагіни:No
- Готовність до друку:No
- 3D Скан:No
- Зміст для дорослих:No
- PBR:No
- Геометрія:Polygonal
- Розгорнуті UVs:Unknown
- Перегляди:7669
Опис
crankshaft with pistons for a 6 cylinders vee-type konfiguration in an schematic manner.originally modelled in cinema4d. detailed enough for close-up renders. the zip-file contains standard materials.
features:
- inside scene: model without textures
- no cleaning up necessary, just drop your models into the scene and start rendering.
- no special plugin needed to open scene.
- phong shading interpolation / smoothing - 35°
- c4d file- obj file - lwo file - 3ds file - fbx file version 2010 Готовність до друку: Ні
English
Español
Deutsch
日本語
Polska
Français
中國
한국의
Українська
Italiano
Nederlands
Türkçe
Português
Bahasa Indonesia
Русский
हिंदी




















1. The short shaft between the 2 plates on which the piston is clamped is on the wrong side. It should be on the opposite side, i.e. the lighter (smaller) side. The heavy side acts as a counter weight to the piston. If this was in a real engine, it would be so badly balanced that it would shake itself to pieces.
2. I have never seen a crankshaft with 2 pistons mounted on the same short shaft. Doesn't mean they don't exist, just they are so much rarer that unless you specify which car the crankshaft is from, it is not a representative model.