Stitched Mismatched Golem 3D Print Model ^NEW

Description

Overall Build

A hulking, asymmetrical construct, about 7.5 heads tall. The posture is heavy and slightly hunched forward. The entire silhouette is off-balance by design.
Body

The body is a patchwork of thick, stitched-together burlap, leather, and hide. Heavy cross-stitching runs across the chest, back, limbs, and head like surgical sutures. The texture is coarse and weathered, not armor plate.
The torso is broad and barrel-chested, with a crude metal pauldron bolted to the right shoulder.
Arms — the key feature

Right arm: massively oversized, heavily wrapped and stitched, ending in a thick, blunt, three-fingered hand. Built for smashing.
Left arm: the opposite — emaciated, exposed, skeletal, and far too long. It hangs past the knee and ends in a long, bony claw with four thin fingers. This asymmetry is the whole character.
Head

A smooth, featureless sack-helm with no face. It has a single, circular, recessed eye in the center of the forehead, surrounded by radial stitching. The back and sides are sewn shut with thick thread.
Coloration

Monochrome dirty beige, brown, and ash grey. The look is desaturated cloth and dried leather — no metal shine, no glow, just grime and stitches.

(Make sure to check if there are any problems with the manifold edges. Most 3d printing aps will have an option to auto fix them, but its also preferable to load them in a viewer for additional checks.
The model has an extent between -1 and 1, you can customize its size and modify it freely. You may reduce or increase the polygon count alongside the vertices freely based on your specific needs. )